The new and improved Carter AccuRight® Circle Cutting Jig quickly and easily attaches to almost any saw, allowing you to cut perfect circles everytime. The Carter AccuRight® Circle Cutting Jig allows you to cut any diameter circle up to four feet, when used with proper external support. With the addition of the adjustable side support assembly, the new Circle Cutter now gives your material even more support when cutting.
Can be mounted to most any saw with the included universal attachment brackets
Cuts perfect lathe blanks and aligns them on your face plate with the Center Master™ (sold separately)
Allows cutting of circles up to 4+ Feet diameter with proper external support (user provided)
New adjustable support piece gives added support around the blade area, for increased control with heavier material like blanks for turnings
No drilling or external mounts necessary
Easy to read radius measurements for precise circle size
Circle thickness only limited by the saw’s resaw capacity
Installs and removes quickly for limited downtime
For use with any blade guide, full block or bearing, (not for use with the Stabilizer® )
Ever find a piece of wood or a log in your firewood pile that would make a beautiful board or book matched piece of veneer, but you just could not figure out how to cut it. The Carter Log Mill™ is the solution. This log mill lets you slice your own wood, veneer or bowl blanks from just about any rough stock or log you have laying around the shop. This simple design incorporates a steel guide bar that uses your miter slot to give you the maximum height for re-sawing as well as even, straight cuts. The heavy duty steel right angle fence keeps the stock from rolling, allowing you to guide the stock through the blade with ease. Adjust the fence for repetitive cuts or once you square off the log you can set up a fence on your saw and slice as many pieces of veneer the log will yield. With wood prices going through the roof, the Carter Log Mill™ will stretch your woodworking dollars by turning that log you were going to burn into your next project.
The AccuRight® Center Master™ Blank Creation System makes it possible to easily and consistently cut and mount circular lathe blanks (for bowl turning, hollow form projects, etc.) using the Carter Circle Cutter (sold separately above ). The device allows even thick pieces of wood to be cut into round blanks and makes it possible to mount these blanks precisely centered onto a lathe faceplate, thus minimizing vibration and getting your project off to a quick and safe start. Precisely cutting the blank also allows you to keep scrap to a minimum and use larger scraps of valuable wood for additional projects. The ACCURIGHT® Center Master consists of two parts: a wide sliding pivot plate for use with the ACCURIGHT® Circle Cutter (sold separately); and the Center Master™ faceplate adaptor mounting jig to ensure perfect centering of the finished blank. The Center Master™ is thread specific so make sure you order the correct size for your faceplate.