The Ball joint fitting is designed to be pressed on
to any 4" tapered diameter opening for a quick and easy fi t. Ball joint prevents kinking of hose at the connection point which allows for great mobility. The opposite end accepts a 4” hose. A hose clamp is required on one end for proper connection

Round dustports are the perfect way to add a dustport to any machine without one. Attach it directly to your machine over an up to 2-5/8" opening with screws (not included). Hose clamps are required for proper connection.

Outer diameters 2-1/2" inlet side x 3-1/2" mounting flange.

Inner diameters 2-1/4" inlet sidex 2-5/8" mounting flange side

4” Router Dustport is a combination of the 4” to 2-1/2” reducer and the right angle router dustport. The small end on the 4” to 2-1/2” reducer fits perfectly inside the right angle port so you can then attach a 4” hose to the larger end of the reducer with a hose clamp. This unit will fit on just about any router table fence system.

2½” Extended Dust port directly accepts a standard
2¼” Shop-Vac® hose end in the dust port opening. No
hose clamp is required for this type of connection. You
can easily attach a standard 2-1/2” dust collection hose
around the outside of the extended dust port opening
with A single hose clamp. The fitting itself attaches to
the back of most router fences.

2½” Low Profile Dustport directly accepts a standard 2¼” Shop-Vac® hose end in the dustport opening. You can also attach a standard 2-1/2” dust collection hose around the outside of the dustport opening with a single hose clamp. The fitting itself attaches to the back of most router fences with two standard wood screws. The low profile makes this fitting an excellent add-on to any drill press fence system.

2½” Router / Bandsaw Dust Port is one of the most popular fittings used in creating an airway on you router table, bandsaw or any other machine that does not come with a dustport. Attaches with 4 screws (not included) on each corner. The dustport will accept a 2-1/2” hose. A hose clamp is required for this type of connection. This fitting will also accept a standard 2¼” Shop-Vac® hose end, no hose clamp is required for this type of connection.

4” Dustport can be used on machines with 4” openings, such as bandsaws and joiners. Attaches with 2 screws (not included) at the top and bottom. The dust port accepts 4” hose. A hose clamp is required for proper connection

4” Flat End Elbow Dust Port Is a great fitting that is fastened directly to your machine when space is limited around the machine. There is no need for all the extra little connector
pieces with this one! A hose clamp is required on one end for proper connection.