he Kreg line of Face Clamps helps to ensure a perfectly
flush joint every time. Without clamping, the joint can
misalign if the screw follows the grain of the wood.
To use, place the large pad of the clamp directly over
the center of the joint line on the face side of the
work piece(opposite the pocket holes), clamp with moderate
pressure and drive a screw.
#1515 Face Clamp
Best for the majority of pocket-screw applications. 3" (76mm) reach will handle workpeices up to 2-3/4" (70mm) thick.
#1516 Large Face Clamp
Good for applications where a slightly longer reach is needed. 6" (152mm) reach will handle workpeices up to 5" (127mm) thick.
#1517 XL Face Clamp
Good for applications where the longest possible reach is required. 10" (254mm) reach will handle workpeices up to 6" (152mm) thick.
All Kreg Face Clamps features an extra-large pad that is placed on the “show side” of the joint to help create a flush joint as the screws are driven. The clamp is also compatible with the Kreg Jig® R3’s Portable Clamp Adapter so the jig can be connected directly to the clamp for high-speed panel drilling. Each Face Clamp has ergonomic padded grips for comfort and ease-of-use.
All Kreg Face Frame Clamps are:
- Ergonomic padded grips for comfort and ease-of-use
- Helps create a flush joint as screws are driven
- Compatible with Kreg Jig® R3’s Portable Clamp Adapter