Ripping on Table Saw

Resaw on Table Saw

Resaw on Bandsaw

Slot cutting on Router Table

This video shows:

The GRRipper feeds the work piece, as the saw blade or router bit passes through either it’s right side or left side tunnel. It uses grooved non-slip pads to feed, grip and hold down your work through the cutting element.

GRIPPER 100

The GRIPPER 100 model is the basic model in the Gripper series. It comes with a 1/4” leg for super thin cuts. Also included are the 1/2” and 3/4” legs. The
3/4” leg is completely adjustable for any width cut.

GRIPPER 200

The Gripper 200 model is the advanced model. It comes with the same great features as the basic model, plus it has an extra leg that can be used to give you extra gripping power for wider stock pieces. The 200 model also comes with the large leveling pad. This pad is primarily used to level your Gripper when cutting small, narrow pieces. Buy a second Gripper so when you have to cut anything longer than 16 inches you have a second GRRipper on hand so you can “daisy chain” your stock through the cutter or blade in a safe and controlled manner. The two packs come with a FREE DVD!

	CLICK HERE for Micro Jig Gr-Ripper Interactive 3D PDF (Requires Adobe Acrobat)

Note: The MJ Handle Bridge Set (Model # GRHB-010) must be installed on your GRR-Ripper® (Model # GR-100 or GR-200) prior to installing the MJ D/C.

Click Here to See
More Details

The MJ Deflector/Connector (D/C) is designed to enhance the user experience of the GRR-Ripper® System. The D/C can be used for chip/dust deflection. It can also serve as a connecting bridge between two GRR-Rippers®, where it allows for multiple configurations when used on the table saw, router table, and shaper. When the D/C is installed behind a GRR-Ripper®, it also serves as a blade cover when exiting the cut on the table saw.

Package Contents

Click Here for
More Details

With the arch shaped MJ Handle Bridge attached, the downward pressure from the handle is spread across the whole width of the GRR-Riper® body through the FOUR contacting points (two from each bridge) instead of through the two mating points directly under the handle without the bridge.  Because of the MJ Bridge Handle enhances the distribution of balanced pressure throughout the GRR-Ripper®, the need of location adjustments of the handle is virtually eliminated.

Microjig Handle Bridge Set and Deflector/Connector Package, see #1381 and #1382 above for details.

This two hour feature-packed video covers over 30 applications of the GRR-Ripper® System on four different  machines.  The following photo galleries preview the contents in the DVD.  For your convenience and ease of navigation, we have created five different galleries to cover each individual professional, each on their own separate page  for shorter loading time.