Microjig Deflector /Connector

Shop

Catalog Index

Departments

How-To Instructions

Woodworking Shows

2009/2010 Calender

Visit Us

Store Directions

Visit Our Specialty Web Sites

allbandsawblades.com

Microjig Deflector /Connector

The MJ Deflector/Connector (D/C) is designed to enhance the user experience of the GRR-Ripper® System. The D/C can be used for chip/dust deflection. It can also serve as a connecting bridge between two GRR-Rippers®, where it allows for multiple configurations when used on the table saw, router table, and shaper. When the D/C is installed behind a GRR-Ripper®, it also serves as a blade cover when exiting the cut on the table saw.

	One D/C is used as a chip deflector and blade cover on a single GRR-Ripper® operation on table saw. This setup can also be used with the leap-frogging technique, but do not lift off the GRR-Ripper® with the D/C attached in this position at an excessive angle.

	One D/C connects two GRR-Rippers® fore and aft, while a second D/C serves as a deflector. An out-feed table is necessary with this configuration! Use of the MJ Splitter is recommended with this setup.

	One D/C connects two GRR-Rippers® for wider cuts.

	Cut as wide as 13-3/4” with saw blade through tunnel.
Back To Microjig Main Page