Visit Our Specialty Web Sites

 

nosawdust.com
ttrackusa.com
justclamps.com
justfreud.com

 

 

Handle-Bridge Microjig Grr-Ripper Accessory

Balanced pressure from the GRR-Ripper® to both sides of the saw blade is the key to better control of the stock during most any table saw operation. In the Instruction Manual, we advise our users to adjust the handle location and secure it with a Philips screw driver so it is directly above the cut line to achieve a better distribution of pressure whenever necessary. For example, when making a 1/4" rip cut, the handle should be secured directly over the saw blade that passes through the right tunnel between the 1/4" Side Leg and the Center Leg and the handle should be relocated to above the left tunnel when making a wider rip rip cut.  This has been proven to be an effective technique for virtually all configurations and uses.
Microjig Bridge Handle Image 1

Arch shaped Handle Bridges distribute the downward pressure to cover the entire width of the GRR-Ripper®.
     
Microjig Bridge-Handle Image 2

Perspective view of pressure distribution with the MJ Handle Bridges

The MJ Handle Bridge, an arch shaped component which provides FOUR (4) contact points with increased widespread coverage.

Virtually eliminates the need to adjust the handle on your GRR-Ripper®.
 

     
Microjig Bridge-Handle Image 3

Significantly improves control by distributing more balanced pressure throughout the non-slip surfaces.

     
Microjig Bridge-Handle Image 4

Bonus - Includes an easy on/off trailing hook template complete with hardware to further enhance your GRR-Ripper® System.