Glue & Accessories

Titebond Instant Bond Accelerator 5.5 ounce Spray Can

Titebond Accelerator has been developed as a treating agent for use with Titebond's Instant Bond adhesives. If faster setting speeds are desired, Titebond's Accelerator will aid the curing process and give faster set times. It will allow for faster uniform curing. The accelerator will aid the bonding of porous materials such as wood. It is useful when bonding acidic surfaces or in low humidity conditions promoting consistent curing times. Using Accelerator will enable the adhesive to fill gaps up to 0.20".

Features:

• Designed for use with all titebond instant bond adhesives
• Accelerates the curing of titebond instant bond adhesives
• Especially effective for large gaps and very porous woods
• Useful when bonding acidic surfaces or in low humidity conditions
• Heptane-based solvent will not mar finishes or damage plastics

Instant Bond Glue & Activator

Instant Bond is a two-part bonding system that takes between 5 - 15 seconds to set and 30 - 60 seconds for initial cure. It provides a strong, permanent bond and is ideal for hard to reach joints or surface areas that are difficult to clamp. This adhesive is also very effective on a variety of materials and substrates.

Thin: Ideal for Wicking Hair Line Cracks
5 second handling - 3 second set Can be used with out activator

Medium: Designed to fill Knots & Voids
7 second handling - 5 second set Soak end grains to prevent splitting

Thick: Designed for Finish & Trim Carpentry
10 second handling - 8 second set Also ideal for MDF & Porous wood

Gel: Excellent for Filling Large Gaps
30second handling - 20 second set Also ideal for MDF & Porous wood

Activator: Accelerates the curing of adhesive with thin, medium, thick and gel with quick Professional results.

Debonder

Removes cyandacrylate glue. Just spread on over unwanted glue and wait 5 to 10 minutes and wipe off with cloth. Repeat if neccassary. Always make sure to use in ventilated area and make sure not to contact with eyes or skin.

Spray-On Accelerator

Dries Glue Instantly!

When bonding, spray glue on one area and apply CA to the opposing area. Position Material together and hold for 20 to 30 seconds.

Whe filling cracks or voids apply glue first, then spray accelerator over glue. Glue will cure in 10 to 20 seconds.

2P-10 Adhesive Kit

2P-10 is a two part ten second bond adhesive. Just apply the adhesive, then spray the activator and stick it together for a strong permanent bond. The 2P-10 Kit comes with Joel, Thick, Medium and Thin Adhesives for bonding different surfaces, Activator for a fast permanent bond, and Debonder for removing glue residue.

• Complete starter kit in a hard shell case!
• Hard-shell case
• 10 second bonding
• 30 seconds to cure
• 4 different viscosities
• Fast, permanent bond
• Works on most surfaces

2P-10 Activator 12 oz. Aerosol

Fastcap 2P-10 Kit Adhesive System is an industrial grade instant glue. It is triple distilled and acidically modified to work specifically with wood. Cabinet makers and carpenters love it and refer to it as the ranch dressing of glue - they use it on everything! 2P-10 can be used on any material as long as it is clean and the surface is well prepared. With the Activator from FastCap you can easily accelerate curing of 2P-10 adhesive. 2P-10 is a two-part, 10 second bond adhesive. Just apply the adhesive, spray with activator, and press together for a strong permanent bond.